The FOX Factory Series Lightweight 1.5 ZERO Intelligent Quick Switch (iQS) kit is tuned specifically for harder backcountry riding with less fatigue, without compromising durability. FOX’s 1.5 ZERO coil-sprung shocks are known for their range of control and supple ride through the chop and crust.
The FOX iQS system is a peerless suspension package tailored specifically for your mountain sled. The electronically controlled suspension system allows you to adjust the performance of your sled in under a second. Depending on the conditions and terrain, tune your sled to provide you optimal control and comfort in any situation. Never take a break to adjust suspension again, thanks to iQS.
We designed the coil-sprung mountain shocks with two primary objectives: weight reduction and ride performance. FOX optimizes the 1.5 ZERO coil-sprung shocks through material reduction without a sacrifice of ride quality or structural integrity. Additionally, the coil springs were redesigned to retain the same spring rate but with fewer coils and built from a lighter steel alloy. The shocks maintain a linear feel regardless of temperature fluctuation, which keeps your sled setup quick and simple. The new coils result in a spring with the same performance at half the weight.
FOX’s position-sensitive damping technology, with origins in desert truck racing, is now applied to the Factory Race Series coil-sprung shocks. Spiral grooves inside the shock allow the oil to flow around the main piston, reducing damping force in the ride zone for a plush feel. The bypass grooves terminate through the final 30% of the travel, forcing oil to only flow through the main piston and providing a significant increase of bottom-out resistance to cushion any hard hits. Our goal was to inspire confidence next time you send it big thanks to the extra support.
FOX iQS is an electronic modal damping control system. This system comprises a Bosch Electronic Control Unit (ECU), custom wiring harness, and electronically actuated valves integrated into each shock:
- The three-button switch mounted to your handlebar puts you in command of four unique shock modes. Each mode changes the character and balance of your sled by adjusting the compression damping of each shock. FOX Backcountry Team member Chris Burandt was instrumental in developing the individual settings and tuning the shocks to his refined taste.
- Are you scaling a near-vertical wall? Utilize lockout mode for better floatation and steering control. Lockout your rear track shock to prevent unwanted weight transfer to the rear to keep the sled planted when you twist the throttle. Worn out from a great day on the peaks and ready to motor back to the truck? Engage soft mode for a plush ride down the mountain.
Between lockout and soft are settings to cover the full spectrum of riding from high-flying action to quick transitions boondocking through the trees. Experience a new sense of control on the snow due to less outboard weight.
The FOX iQS system is a straightforward DIY install supported by a thorough step-by-step manual, online videos, and of course, our friendly FOX Service Center technicians.
Features | Optimized lightweight shock design |
---|---|
Spiral groove bypass | |
One-piece, aluminum spherical bearings | |
Model-specific optimized ride tune | |
Complete shock kit (four shocks) | |
Plug ‘n Play wiring harness | |
Bosch ECU | |
On-the-fly, push button adjustments | |
High-speed response time: full range adjustment takes place in less than one second | |
1.5-inch 6061-T6 aluminum type III hard-anodized bodies | |
LED back-lit handlebar switch | |
Advanced high-flow, deflective disc velocity-sensitive damping | |
Gas-charged mono-tube piggyback with internal floating piston (IFP) design | |
Fully rebuildable and re-valvable | |
Ski Extended Length | 17.630 |
Ski Compressed Length | 11.580 |
Ski Travel | 6.050 |
Front Track Extended Length | 14.280 |
Front Track Compressed Length | 9.830 |
Front Track Travel | 4.450 |
Rear Track Extended Length | 17.310 |
Rear Track Compressed Length | 11.130 |
Rear Track Travel | 6.180 |
Top Mount | Eyelet |
Bottom Mount | Eyelet |
Rebuild P/n | SKI - 803-01-379; FT - 803-01-379; RT - 803-01-356 |
Ski Extended Length | 17.6300 |
Ski Compressed Length | 11.5800 |
Ski Travel | 6.0500 |
Front Track Extended Length | 14.2800 |
Front Track Compressed Length | 9.8300 |
Front Track Travel | 6.1800 |
Rear Track Extended Length | 14.2800 |
Rear Track Compressed Length | 11.1300 |
Rear Track Travel | 6.1800 |
Fitment notes | Complete Vehicle |